You can then use the Disable monitor power save mode command to reactivate the signal on the HDMI and VGA ports, thus turning the display back on. The Enable monitor power save mode command places the display into standby by turning off the video signal from the BrightSign player. You can enable or disable monitor power save mode, which kills the signal on the HDMI and VGA ports. If you look at the 3rd digit in your serial # on the BrightSign, it says what rev the unit is. Note (for HD110-HD1010 models): CEC is only supported on our rev G units. You can also select the Send Ascii String command to send a custom CEC command. Use the Display On or Display Off commands to send 'on' or 'off' commands to the display.Select BrightControl from the Commands drop-down list:.Open the state or event when you want the CEC command to be executed.Create or open an interactive presentation.There are default commands for 'on' and 'off', or you can send custom CEC strings for other commands. You should also use the latest BrightAuthor and firmware production releases. You can check in the display manual whether CEC commands are supported or not. Using CEC commandsĬEC commands work over HDMI only and require a display that supports CEC over HDMI. Watch this tutorial video to learn more about sending serial commands. These actions can be done using an interactive playlist or a custom script. Players can also be used to place a monitor into a power-save mode at specified times. Yes, BrightSign players can be configured to send serial and CEC commands to your display, including turning it off and on at specified times.

Samsung rs232 power on command